臭氧發生器的種類和特點
- 發布人：
- 發布日期：2017-04-13 17:14:19
1. 中央空調內置型臭氧發生器
1 central air conditioning with built-in ozone generator
將臭氧發生器安置在中央空調送風道或回風道內部，利用空調的風力將臭氧發生器產生的臭氧輸送到需要消毒的車間內。這種臭氧發生器使用簡單，臭氧氣體也能方便地投送到需要消毒的車間內。
The ozone generator is placed in the central air conditioning send duct or return within the Tao, the use of air conditioning wind will be generated ozone generator ozone transported to the need for disinfection of the workshop. The ozone generator is simple to use, the ozone gas can be easily delivered to the need for disinfection of the workshop.
但由于是安置在空調風道內，所以發生故障時，不易察覺，維修也不方便；另外如果空調風不潔凈的話，對臭氧放電體等配件的損害是很嚴重的。所以這種方式已經逐步被淘汰。
But because it is placed in the air conditioning duct, so when the failure is not easy to detect, maintenance is not convenient; in addition, if the air conditioning air is not clean, the damage to the ozone discharge body and other accessories is very serious. So this way has gradually been phased out.
2. 中央空調外置型臭氧發生器
2 central air conditioning external type ozone generator
將臭氧發生器的臭氧出口通過管路送入中央空調送風道內，和內置型臭氧發生器相比，這種方式不僅僅是方便安裝和維護，而且臭氧發生器不受空調風的影響。
The ozone generator ozone is sent through the pipeline into the central air-conditioning duct, and the built-in ozone generator, this way is not only convenient for the installation and maintenance, and the ozone generator is not affected by air conditioning.
如果沒有中央空調，可以在車間較高處鋪設管道，在管道上開孔，也可以很好的將臭氧輸送到整個空間。這種方式有幾個好處：一是能夠遠距離輸送臭氧，并且使臭氧均勻散布；二是一臺臭氧發生器可以對多個車間進行消毒，或只針對特定的車間消毒；三是可以將臭氧發生器安放在被消毒車間外，避免車間潮濕對臭氧發生器的損壞。
If there is no central air conditioning, can be higher in the workshop to lay pipes, open hole in the pipeline, but also very good to transport the whole space. This approach has several advantages: first, to transport ozone, and so that the ozone evenly distributed; two is a ozone generator can be used to disinfect a number of workshops, or only for a specific workshop disinfection; three can be placed in the ozone generator is disinfected, to avoid the workshop humidity damage to the ozone generator.
3. 壁掛式臭氧消毒機
3 LHK
將臭氧消毒機懸掛在車間內墻壁的高處，通過臭氧消毒機內置的風機將臭氧氣體吹送到車間內。這種臭氧消毒機由于結構、風力等方面的限制，只適用于小空間的滅菌除味，當車間面積較大時，需要安裝多臺才能達到消毒效果。
The ozone disinfection machine is suspended in the high place of the wall of the workshop, and the air blower of the ozone disinfection machine will blow the ozone gas into the workshop. This ozone disinfection machine due to the structure, wind and other aspects of the limit, only for small space of sterilization in addition to taste, when the workshop area is larger, need to install more than one can achieve disinfection effect.
4. 便攜式臭氧發生器
4 portable ozone generator
上部帶有提手的臭氧消毒機,可隨意移動到需要消毒的空間內使用。由于臭氧比空氣重，對空間消毒時，最好將臭氧發生器放在較高的位置使用。這種臭氧發生器和壁掛式類似，只是移動性強一些，適合小空間內使用。
The upper part of the ozone disinfection machine with handle, can be moved to the space in need of disinfection. Because ozone is heavier than air, it is best to use ozone generator in high position when space is disinfected. The ozone generator and a wall mounted similar, only strong mobility, suitable for use in small space.
五、臭氧投加量的計算
Five, the calculation of ozone dosage
臭氧投加量需要根據車間容積大小、消毒時間來確定。比如說，一個普通的1000立方米的車間消毒一小時（不包括30分鐘的臭氧后續消毒時間），那么按照不低于10mg/m³臭氧濃度的要求，這1000立方米的車間在一小時內需要投入10000mg臭氧（即10g）。如果是鋪設管道的方式則需要加大20%-30%的臭氧投加量。
The amount of ozone dosage should be determined according to the size of the shop floor and the disinfection time. For example, an ordinary 1000 cubic meters of workshop disinfection for an hour (not including 30 minutes of ozone follow-up disinfection time), then in accordance with the requirements of not less than 10mg/m³ ozone concentrations, the 1000 cubic meters of workshop in an hour need to be put into 10000mg ozone (ie 10g). If it is the way of laying pipelines need to increase the amount of ozone 20%-30%.
